Antenna Rotator System - RCI Boards

The RCI has been tested with almost commercial rotators. It has been designed as an Universal Rotor Interface, it means, it can be adapted to all existing rotors. On the manual a step by step instalation guide will help you to make the setup on most common rotors models. This is possible by using some varible resistors (trimmers), that let you set the optimum calibration.

Some of the most popular rotors verified are:

Compatible Rotators:

• Yaesu: G400S, G500 & G500A (Ele), G800S, C, SDX & DXA, G1000S,C, SDX, DXA & DXC, G2000S & RC, G2800DXA, G5400, G5500, G5600, etc.
• Telex/Hy-Gain: HAM-IV, HAM-M, T2X, HDR-300
• Kenpro: KR-400, KR450XL, KR-500(Elevation), KR-600RC, KR.650XL, KR-600RC, KR600S, KR-800, KR-1000, KR-5400 & 5600 (Az&El)
• Daiwa: DR-7500 serie R and X, DR-7600 serie R and X
• ORION: 2300, ...
• CREATIVE: RC5x-3P, RC5-1, RC5-x series.
• EMOTATOR: 1105, EV700X
• EMOTO: 1200 FXX
• Pro.Sis.Tel: With All models

If you have any other rotor not included above, you can send me a message, containing its schematic diagram, and I'll answer you whether it's possible to adapt to or not. But sure it will be supported.